How to maintain a blower


1. Under normal operating conditions, after the fan has run continuously for about one month, use a grease gun to inject calcium‑sodium grease or molybdenum disulfide grease into the bearings. After 3–6 months of continuous operation, replace the grease once, filling approximately two-thirds of the bearing space. 2. Perform regular maintenance on the fan to remove accumulated dust, dirt, and other contaminants inside the unit. 3. During startup, shutdown, or operation, if any abnormal conditions—such as unusual temperature, vibration, or noise—are detected, immediate inspection and repair are required. 4. Use the adjusting mechanism to keep the V‑belts consistently and evenly tensioned; avoid excessive looseness or tightness. The lengths of several V‑belts…

  1. Under normal operating conditions, after approximately one month of continuous operation, the bearings should be lubricated with a grease gun using calcium‑sodium grease or molybdenum disulfide grease. After 3 to 6 months of continuous operation, the grease should be replaced, filling about two-thirds of the bearing cavity.
 
  2. Perform regular maintenance and servicing of the fan to remove accumulated dust, dirt, and other contaminants from inside the unit.
 
  3. During startup, shutdown, or operation of the fan, if any abnormal conditions are detected—particularly in terms of temperature, vibration, or noise—immediate maintenance shall be performed.
 
  4. Use the adjusting device to keep the V-belts consistently and evenly tensioned; they must neither be too loose nor too tight. The lengths of multiple V-belts should be as uniform as possible.
 
  5. For standby units that are not in use or for fans that have been out of service for an extended period, the rotor should be rotated by 120°–180° at regular intervals to prevent shaft bending. Install valves at the fan’s inlet and outlet; close them during startup, and open them once the fan is running, until the specified operating conditions are reached, ensuring proper clearance between the inner race and the shaft.

Leave a message for inquiry

Thank you for visiting. If you have any other questions, please leave us a message, and we’ll get back to you as soon as possible!


Note: Fields marked with an asterisk (*) are required. Thank you!

Submit Message

Leave a message for inquiry

Thank you for visiting. If you have any other questions, please leave us a message, and we’ll get back to you as soon as possible!

Note: Fields marked with an asterisk (*) are required. Thank you!

Submit Message